Komatsu — INFORMATION DESCRIBED IN TROUBLESHOOTING LIST

TROUBLESHOOTING INFORMATION DESCRIBED IN TROUBLESHOOTING LIST INFORMATION DESCRIBED IN TROUBLESHOOTING LIST a Troubleshooting lists and related circuit diagrams contain the following information all together. Understand the contents carefully and troubleshoot the machine. Related circuit diagram This is the excerpted circuit diagram related to trouble Connector No.: Indicates (Model-No. of pins) (Color). Arrow ( ): Roughly indicates mounting place on machine. 20-602 D85EX-15 (1) Trouble Problem that appears on the machine.

Related information Information related to problems occurred or troubleshooting Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Cause by which a trouble is as- sumed to be detected (The order number indicates a serial number, not a priority se- quence.) • Standard value in normal state required to judge the assumed cause (good or not) • Remarks required to judge whether the cause is good • Disconnection in wiring The connector connection is defective or the wiring harness is disconnected. • Grounding fault A harness not connected to the ground (earth) circuit comes into contact with the ground (earth) circuit.

• Defective hot short A harness not connected to the power (24V) circuit comes into contact with the power (24V) circuit. • Defective short A harness of an independent circuit abnormally comes into con- tact with one of another circuit. (1) Method of indicating connector numbers and handling T-junc- tion For troubleshooting, insert or connect the T-junction adapter as shown below unless especially specified. • When “male” or “female” is not indicated for a connector number, disconnect the connector, and insert the T-junction adapter in both the male and female.

• When “male” or “female” is indicated for a connector num- ber, disconnect the connector, and insert the T-junction adapter in only either the male or female. (2) Pin number description sequence and tester lead handling For troubleshooting, connect the plus (+) and minus (–) leads as shown below unless especially specified. • Connect the plus (+) lead to a pin or harness indicated in the front. • Connect the minus (–) lead to a pin or harness indicated in the rear. 2 3 4