TROUBLESHOOTING E-1 E-1 THE ENGINE DOES NOT START D85EX-15 20-603 (1) Trouble • The engine does not start. Related information • The engine start circuit has the neutral safety function, and the engine does not start unless the parking lever is set to the lock position. • If “the monitor panel does not come on” or “the battery relay does not cause operating sound” when the starting switch is set to ON, the main electric power supply system is supposed to be out of order. So, inspect the main electric power supply system.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Insufficient battery capacity Battery voltage Battery specific gravity Min. 24V Min. 1.26 2 Defective starting switch (in- ternal disconnection) aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. Starting switch Switch position Resistance Between 250 (B) and 280 (C) OFF Min. 1Mz START Max. 1z 3 Defective neutral safety re- lay (internal disconnection) aPrepare with the starting switch OFF, then start the engine and carry out troubleshooting.
If the engine starts in accordance with the engine starting arrangement after the neutral safety relay (NSF) is replaced with another one while the starting switch is set to OFF, the relay is defective. 4 Defective alternator (internal short-circuit) aPrepare with the starting switch OFF, then turn the starting switch ON and carry out troubleshooting. Alternator Voltage Between Terminal R and ground Max. 1V 5 Detective starting motor (in- ternal defect) aPrepare with the starting switch OFF, then start the engine and carry out troubleshooting. Starting motor Voltage Electric power supply : between Terminal ST/B and ground 20 – 30V Charge : between ST (2) and ground Max. 1V Starting :
between ST (1) and ground 20 – 30V When the voltages of electric power supply, for charging and starting are normal but the starting motor does not rotate, the starting motor is defective. 6 Disconnection in wiring har- ness (disconnection in wir- ing or defective contact in connector) aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. Wiring harness between 280 (C) and NFS (fe- male) (3) Resistance Max. 1z Wiring harness between NSF (female) (5) and ST (female) (1) Resistance Max. 1z Wiring harness between NSF (female) (5) and EGC1 (female) (20) Resistance Max.
1z 7 Hot short circuit of wiring harness (Contact with 24V circuit) aPrepare with the starting switch OFF, then turn the starting switch ON and carry out troubleshooting. Hot short circuit of wiring harness between al- ternator R terminal and ST (female) (2) or STC1 (female) (15) or S04 (female) (9) with ground (Note : While a hot short circuit occurs, the bat- tery charge level lamp comes on when the start- ing switch is turned ON.) Voltage Max. 1V