TROUBLESHOOTING E-7 E-7 WHILE THE ENGINE IS OPERATING, THE EMERGENCY WARNING ITEM FLASHES. Circuit diagram related to engine oil low pressure switch and engine oil high pressure switch 20-612 D85EX-15 (1) Trouble (1) • The engine oil pressure caution lamp flashes. Related information • When any abnormality is detected during engine operation, the engine oil pressure caution lamp will flash and sound the alarm buzzer. • The engine oil pressure switch signal is sent and received from the engine controller through commu- nication. Possible causes and standard value in normal state Cause Drop of engine oil pressure 1 (when the system is normal) The engine oil low pressure 2 switch is defective.
(Internal short circuit) The engine oil high pressure 3 switch is defective. (Internal short circuit) Ground fault of wiring har- 4 ness (Contact with ground circuit) 5 Defective engine controller 6 Defective monitor panel Standard value in normal state/Remarks on troubleshooting Drop of engine oil pressure (when the system is normal) Check the engine oil pressure as the drop of engine oil pressure is de- tected. The engine oil low pressure switch is defective. (Internal short circuit) aPrepare with the starting switch OFF, then carry out troubleshooting without turning the switch ON or after starting the engine. PSL Engine Resistance Between terminal and ground Stop Max. 1z Min. 600rpm Min.
1Mz The engine oil high pressure switch is defective. (Internal short circuit) aPrepare with the starting switch OFF, then carry out troubleshooting without turning the switch ON or after starting the engine. PSH Engine Resistance Between terminal and ground Stop Max. 1z Min. 1,300rpm Min. 1Mz Ground fault of wiring har- ness (Contact with ground circuit) aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. Between wiring harness (between EGC1 (fe- male) (21) and PSL) and ground Resistance Min. 1Mz etween wiring harness (between EGC1 (fe- male) (15) and PSH) and ground Resistance Min.
1Mz Defective engine controller aPrepare with the starting switch OFF, then carry out troubleshooting without turning the switch ON or after starting the engine. EGC1 Engine Voltage Between (21) and ground Stop Max. 1V Min. 600rpm 20 – 30V Between (15) and ground Stop Max. 1V Min. 1,300rpm 20 – 30V Defective monitor panel This is an internal defect, which cannot be troubleshot.