TROUBLESHOOTING E-11 E-11 THE HYDRAULIC OIL TEMPERATURE GAUGE DOES NOT INDICATE NOR- MALLY. Circuit diagram related to hydraulic oil temperature sensor D85EX-15 20-619 (1) Trouble • Th e hydraulic oil temperature gauge does not indicate normally. • Sig Related ler information • W [D nals of the hydraulic oil temperature sensor are received from the steering and transmission control- through communication. hen any abnormality occurred in the hydraulic oil temperature sensor system, the failure code GS1KX] is displayed sometimes.
1 2 Possible causes and standard value in normal 3 state 4 5 6 Cause Standard value in normal state/Remarks on troubleshooting The hydraulic oil tempera- ture sensor is defective. (In- ternal disconnection or short circuit) aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. SDS (male) Resistance Between (1) and (2) 3.5k – 90kz Between (1) and ground Min. 1Mz Disconnection of wiring har- ness (Disconnection in wir- ing or defective contact in connector) aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON.
Wiring harness between STC1 (female) (14) and SDS (female) (1) Resistance Max. 1z Wiring harness between STC1 (female) (21) and SDS (female) (2) Resistance Max. 1z Ground fault of wiring har- ness (Contact with ground circuit) aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. Between wiring harness (between STC1 (fe- male) (14) and SDS (female) (1)) and ground Resistance Min. 1Mz Hot short circuit of wiring harness (Contact with 24V circuit) aPrepare with the starting switch OFF, then turn the starting switch ON and carry out troubleshooting.
Between wiring harness (between STC1 (fe- male) (14) and SDS (female) (1)) and ground Voltage Max. 5V Defective transmission con- troller aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. STC1 (female) Resistance Between (9) and (21) 3.5k – 90kz Between (9) and ground Min. 1Mz Defective monitor panel This is an internal defect, which cannot be troubleshot.