Komatsu — E-20 THE MANUAL MODE DOES NOT OPERATE OR CANNOT BE RESET

TROUBLESHOOTING E-20 E-20 THE MANUAL MODE DOES NOT OPERATE OR CANNOT BE RESET. Circuit diagram related to manual mode 20-628 D85EX-15 (1) Trouble • The manual mode does not operate or cannot be reset.

Related information Possible causes and standard value in normal state Cause a Defective manual mode 1 switch (Internal disconnec- tion) a Disconnection of wiring har- ness (Disconnection in wir- W 2 ing or defective contact in M connector) W gr a Ground fault of wiring har- 3 ness (Contact with ground C circuit) m a Defective steering and 4 transmission controller a Defective steering and 5 transmissioncontroller Standard value in normal state/Remarks on troubleshooting a efective manual mode witch (Internal disconnec- on) Preare with the starting OFF, then carry out troubleshooting without turning the starting switch ON.

MAM (male) Manual mode switch Resistance Between (2) – (3) OFF (0) Min. 1Mz ON (1) Max. 1z a isconnection of wiring har- ess (Disconnection in wir- W g or defective contact in M onnector) W gr Prepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. iring harness between STC2 (female) (10) – AM (female) (2) Resistance M ax. 1z iring harness between MAM (female) (3) – ound Resistance M ax. 1z a round fault of wiring har- ess (Contact with ground C rcuit) m Prepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch ON.

ontact of wiring harness between STC2 (fe- ale) (10) – MAM (female) (2) with ground Resistance M in. 1z a efective steering and ansmission controller Prepare with the starting switch OFF, then turn the starting switch ON and carry out troubleshooting. STC2 Manual mode switch Voltage Between (10) and ground OFF (0) 20 – 30V ON (1) Max. 3V Manual mode switch Resistance a efective steering and ansmissioncontroller When Causes 1 to 4 are not applicable, the steering and transmis- sion controller may be defective. (Since the system is defective, the control system cannot be troubleshot.)