TROUBLESHOOTING E-24 D85EX-15 20-639 (1) Trouble (3) • The rear wiper does not operate (Continuous operation is defective). Related information • Carry out the following troubleshooting when only the rear wiper is defective. • If any wiper does not operate, check the fusible link (96A). • When carrying out the troubleshooting, turn the intermittent switch OFF and turn the wiper switch ON. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective circuit breaker (96A) If the circuit breaker is turned OFF, the circuit probably has a grounding fault, etc.
2 Defective fuse (4) in cab Since fuse (4) in the cab is used for only the rear wiper system, this system probably has a grounding fault, etc. 3 Defective rear wiper motor aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Between CN37 (1) – ground Voltage 20 – 30V aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between CN37 (female) (2) – ground Resistance Max. 1z 4 Defective rear wiper switch aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. CN12 (male) Position of switch Resistance Between (3) – (4) ON Max. 1z OFF Min.
1 Mz 5 Defective rear wiper inter- mittent selector relay • If the trouble is repaired by replacing the relay with relay CN27, CN29, or CN31, the relay is defective. aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Between CN33 (3) – ground Voltage 20 – 30V Between CN33 (6) – ground Voltage 20 – 30V Between CN33 (1) – ground Voltage 20 – 30V 6 Defective rear wiper inter- mittent relay • If the trouble is repaired by replacing the relay with relay CN26, CN28, or CN30, the relay is defective. aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting.
Between CN32 (4) – ground Voltage 20 – 30V Between CN32 (3) – ground Voltage 20 – 30V Between CN32 (5) – ground Voltage 20 – 30V 7 Disconnection or short cir- cuit with chassis ground in wiring harness (Disconnec- tion in wiring or defective contact in connector or con- tact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between CN12 (female) (4) – CN33 (female) (3) Resistance Max. 1z Contact of wiring harness between CN12 (fe- male) (4) – CN33 (female) (3) with ground Resistance Min. 1 Mz Wiring harness between CN33 (female) (6) – CN32 (female) (4) Resistance Max.
1z Contact of wiring harness between CN33 (fe- male) (6) – CN32 (female) (4) with ground Resistance Min. 1 Mz