TROUBLESHOOTING E-25 * For the electric circuit diagram of each system, see Trouble (1). D85EX-15 20-655 (1) Trouble (4) • Washing water of the right door washer does not come out. Related information • Carry out the following troubleshooting when the right door wiper operates normally. (If the wiper does not operate either, carry out troubleshooting in E-24 THE WIPER DOES NOT OPERATE first. • Since the right door wiper switch and left door wiper switch use fuse (6) jointly, if fuse (6) is broken, both wipers do not operate.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective right door washer motor aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between 363 (male) (2) – ground Resistance Max. 1z aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Between 363 (2) – ground Voltage 20 – 30V 2 Defective right door wiper switch aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. CN13 (female) Position of switch Resistance Between (2) – (1) W/ or W/ Max. 1z OFF Min.
1 Mz 3 Disconnection or short cir- cuit with chassis ground in wiring harness (Disconnec- tion in wiring or defective contact in connector or con- tact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between fuse (6) – CN13 (fe- male) (2) Resistance Max. 1z Contact of wiring harness between fuse (6) – CN13 (female) (2) with ground Resistance Min. 1 Mz Wiring harness between CN13 (female) (1) – 19 (2) – 363 (female) (1) Resistance Max. 1z Contact of wiring harness between CN13 (fe- male) (6) – 19 (2) – 363 (female) (1) with ground Resistance Min.
1 Mz Wiring harness between 363 (female) (2) – ground Resistance Max. 1z