TROUBLESHOOTING H-2 H-2 MACHINE DOES NOT MOVE (AT 2ND OR 3RD SPEED) 20-704 D85EX-15 (1) Trouble • Machine does not move. (At 2nd or 3rd speed) Related information • Confirm that the oil quantity on the power train is normal before troubleshooting. • Confirm that the transmission main relief pressure is normal before troubleshooting. (See H-1.) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Internally defective torque converter aPrepare with starting switch OFF, then drive the engine in high idling mode for troubleshooting. PCCS lever Original pressure of torque converter Torque converter delivery pressure Full neutral Max.
1.02MPa {Max. 10kg/cm2} 0.61 – 0.81MPa {6 – 8kg/cm2} 2 Defective transmission valve (ECMV) function aPrepare with starting switch OFF, then drive the engine in low idling mode for troubleshooting. Transmission clutch Clutch pressure 2ND Min. 2.35MPa {Min. 24kg/cm2} 3RD Min. 2.55MPa {Min. 26kg/cm2} 3 Internally defective trans- mission clutch The transmission clutch (2nd or 3rd speed) is assumed to be defective internally; directly check it. 4 Defective parking brake function (Drag) The parking brake function is assumed to be defective (dragged); check the linkage valves. 5 Defective brake function (Drag) aMove to a flat place, and start the engine for troubleshooting.
If the machine does not run by low idling + F2 operation, brake drag occurs. (Carry out troubleshooting “Brake does not work.”) 6 Internally defective trans- mission The transmission is assumed to be defective internally; directly check it.