TROUBLESHOOTING H-3 H-3 MACHINE DOES NOT MOVE IN ANY SPEED RANGE D85EX-15 20-705 (1) Trouble • Machine does not move in any speed range. Related information • Confirm that the oil quantity on the power train is normal before troubleshooting. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective power train pump The power train pump is assumed to be defective; directly check it. 2 Defective and Internally de- fective set pressure of transmission main relief valve aPrepare with starting switch OFF, then drive the engine in high idling mode for troubleshooting. PCCS lever Transmission main relief pressure Full neutral Min.
2.84MPa {Min. 29kg/cm2} aPrepare with the starting switch OFF, then carry out troubleshooting without turning the starting switch ON. Directly check that the spring length and the number of shims are nor- mal and also that the spool rotates smoothly. • Free length of large spring: 128mm • Free length of small spring: 108mm • Number of shims: 6 3 Defective transmission valve (ECMV) function aPrepare with starting switch OFF, then drive the engine in low idling mode for troubleshooting. (Before this, confirm that the transmission main relief pressure is normal.) Transmission clutch Clutch pressure FWD Min. 1.96MPa {Min. 20kg/cm2} REV Min. 2.55MPa {Min. 26kg/cm2} 1ST Min. 2.16MPa {Min.
22kg/cm2} 2ND Min. 2.35MPa {Min. 24kg/cm2} 3RD Min. 2.55MPa {Min. 26kg/cm2} 4 Internally defective trans- mission clutch The transmission clutch is assumed to be defective internally; directly check it. 5 Defective brake function aMove to a flat place, and drive the engine in high idling mode for trou- bleshooting. (Before this, confirm that the transmission main relief pressure is normal.) Brake pedal Brake hydraulic pressure (left/right) Release Min. 2.45MPa {Min. 25kg/cm2} Pedal 0 {0} When the hydraulic pressure is abnormal, carry out troubleshooting “Brake does not work.”