TROUBLESHOOTING H-8, H-9 H-8 BRAKE DOES NOT WORK H-9 OVERHEAT OF POWER TRAIN OIL TEMPERATURE D85EX-15 20-709 (1) Trouble • Brake does not work. Related information • Confirm that the oil quantity on the power train is normal before troubleshooting. • Confirm that the main relief pressure for transmission is normal before troubleshooting. (See H-1.) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective brake valve func- tion aPrepare with starting switch OFF, then drive the engine in high idling mode for troubleshooting. Brake pedal Brake hydraulic pressure At release Min. 2.45MPa {Min.
25kg/cm2} At pedaling 0 {0} 2 Defective adjustment of brake pedal linkage If the troubleshooting in cause 1 is abnormal, the adjustment of the brake pedal linkage is assumed to be abnormal; directly check it. 3 Defective brake seal If the troubleshooting in cause 1 is abnormal, the brake seal is as- sumed to be defective; directly check it. 4 Slipped or abrasive brake disk plate The brake disk plate is assumed to be slipped or abrasive; directly check it. Trouble • The oil temperature of the power train overheats. Related information • Confirm that the oil quantity on the power train is normal before troubleshooting.
• Confirm that the value of the oil temperature of the power train matches the actual oil temperature be- fore troubleshooting. (If they do not match, carry out troubleshooting “Abnormal Power Train Oil tem- perature.”) • Confirm that the main relief pressure for transmission is normal before troubleshooting. (See H-1.) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective engine system The engine cooling system is assumed to be defective or the engine output is assumed to be increased; see the Shop Manual: Engine.
2 Defective power train pump or air from suction circuit aThe power train pump is assumed to be defective or aired from the suction circuit; directly check it. 3 Internally defective torque converter aPrepare with starting switch OFF, then drive the engine in high idling mode for troubleshooting. PCCS lever Original pressure of torque converter Torque converter delivery pressure Full neutral Max. 1.02MPa {Max. 10kg/cm2} 0.61 – 0.81MPa {6 – 8kg/cm2} 4 Defective transmission clutch function (Slip) The transmission clutch is assumed to be defective internally (slipped); directly check it. 5 Defective brake function (Drag) aPrepare with starting the engine for troubleshooting. 1.
Use the blades and ripper to float the machine from the ground. 2. Convert the drive position while low-idling. 3. If the track shoe does not rotate, brake drag occurs. (Carry out troubleshooting "Brake does not work.") 6 Defective brake function (Slip) aPrepare with starting the engine for troubleshooting. Carry out F3 stall. If the machine does not stop completely, brake slip occurs.