TROUBLESHOOTING H-18 H-18 EXCESSIVE HYDRAULIC DRIFT OF RIPPER LIFT 20-714 D85EX-15 (1) Trouble • Excessive hydraulic drift of ripper lift. Related information • Confirm whether the ripper is remodeled. • Confirm that no oil leaks the circuits in the work equipment before troubleshooting. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective seal of ripper lift operation valve (Spool) aPrepare with starting the engine, then stop the engine for trouble- shooting. Follow the procedure below for troubleshooting.
If the hydraulic drift speed becomes high, the spool seal of the ripper lift operation valve (Hi) is assumed to be defective. 1. Prop up the machine using the blade tilt, and lift the rear of the ma- chine. 2. Stop the engine, and release the safety lock lever. 3. Set the blade lever to the lift lowering side, and confirm how the phenomenon changes. 2 Defective seal of ripper lift cylinder aPrepare with starting switch OFF, then drive the engine in high idling mode for troubleshooting. Ripper lift cylinder Cylinder leak quantity Lowering stroke end 16cc/min