DISASSEMBLY AND ASSEMBLY FUEL SUPPLY PUMP 12) Tighten bolt A1-2 and remove the gear and fuel supply pump (32). INSTALLATION 3 Removing torque of gear: Approx. 196 – 294 Nm {Approx. 20 – 30 kgm} Carry out installation in the reverse order to removal. [*1] 3 Fuel return hose: 54 – 93 Nm {5.5 – 9.5 kgm} [*2] k Do not correct the high-pressure pipe by bending before installing it. k Be sure to use the genuine high-pressure pipe clamp and observe the tightening torque. k Install the high-pressure pipe and wiring harness at least 10 mm apart from each other. a When installing each high-pressure pipe, check the taper seal of its joint (Part a :
Part of 2 mm from the end) for visible lengthwise slit b and spot c and check part d (End of taper seal: Part of 2 mm from the end) for stepped-type wear caused by fatigue which your nail can feel. If there is any of those defects, it can cause fuel leakage. In this case, replace the high-pressure pipe. a Take care not to drop the woodruff key of the supply pump shaft. a Do not remove bracket A1-3 until you will install the supply pump assembly again. 30-16 D85EX-15 (3)