Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY FUEL INJECTOR 11. Remove common rail-side sleeve nuts (17) and fuel injector-side sleeve nuts (18) of high-pres- sure pipes (16). [*6] INSTALLATION Carry out installation in the reverse order to removal. 12. Remove head cover (19). [*7] [*4] [*5] [*6] k Do not bend the high-pressure pipes before using them. k Be sure to use the genuine high-pressure pipe clamps and tighten them to the speci- fied torque. k Install the high-pressure pipes and wiring harness at least 10 mm apart. a When installing each high-pressure pipe, check the taper seal of its joint (Part a : Part of 2 mm from the end) for visible lengthwise slit b and spot c and check part d (End of taper seal:

Part of 2 mm from the end) for stepped-type wear (fatigue) which your nail can feel. If any of those defects may cause fuel leakage, replace the high-pressure pipe. 13. Remove wiring harness (20) from the fuel injec- tor. [*8] 14. Remove holder mounting bolts (21), and then remove the holder and fuel injector assembly (22) together. [*9] [*1] 3 Hose clamp: 8.8 ± 0.5 Nm {0.9 ± 0.5 kgm} [*2] 3 Band clamp: 9.8 – 11.76 Nm {1.0 – 1.2 kgm} [*3] 3 Air intake hose clamp: 6.8 ± 0.49 Nm {69 ± 5 kgcm} 30-18 D85EX-15 (2)