DISASSEMBLY AND ASSEMBLY FUEL INJECTOR [*4] [*5] [*6] a Install high-pressure pipes (16) between the fuel injector and common rail according to the following procedure. 1) Tighten 6 high-pressure pipes securely. [*5] a Direct the slit of the common rail-side cover toward the cylinder block. a Direct the slit of fuel injector-side cover (12) toward position a shown in the figure. 3 Fuel injector-side sleeve nut: 39.2 – 49 Nm {4 – 5 kgm} 3 Common rail-side sleeve nut: 39.2 – 49 Nm {4 – 5 kgm} 2) Tighten high-pressure pipe clamps (14) and (15), high-pressure pipe clamp plates (23) and (24), and high-pressure pipe clamp (11) temporarily with the fingers.
3) Tighten high-pressure clamps (11), (14), and (15) permanently. 3 Clamp bolt: 11.8 – 14.7 Nm {1.2 – 1.5 kgm} 4) Set high-pressure clamp plates (23) and (24) horizontally and tighten them permanently. 5) Install high-pressure pipe clamp (9) and gate-type frame (10) temporarily. 6) Tighten high-pressure pipe clamp (9) perma- nently first, then tighten gate-type frame (10) permanently. [*7] 3 Head cover mounting bolt: 9.8 ± 1 Nm {1.0 ± 0.1 kgm} 3 Clamp bolt: 11.8 – 14.7 Nm {1.2 – 1.5 kgm} [*8] 3 Wiring harness capture nut: 2.0 – 2.4 Nm {0.2 – 0.24 kgm} D85EX-15 30-19 (2)