Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY ENGINE FRONT SEAL INSTALLATION [*1] Strain the belt according to the following pro- cedure. 1) Loosen mounting bolt (2), nut (3), and bolt (4). 2) Strain the belt with nut (3). 3) Tighten mounting bolt (2), nut (3), and bolt (4). a Tension of belt: 13 mm (When pressed with finger to about 58.8 N {6 kg}) [*2] a Tension of belt: 16 – 20 mm (When pressed with finger to about 98 N {10 kg}) ii) Evenly push in the metallic ring of seal (12) with both hands, getting over the large diam- eter side of the internal plastic cylinder. iii) After pushing in seal (12), remove internal plastic cylinder (13). a When removing, take care not to dam- age the seal lip.

[*3] 3 Mounting bolt (9): 245 – 308.7 Nm {25 – 31.5 kgm} 3 Mounting bolt (10): 56.8 – 196 Nm {16 – 20 kgm} [*4] 4) Procedure for installing front seal (12) a Before installing the seal, check the rims of the crankshaft end, sliding faces of the lip, and housing for flaw, burr, sharp fin, rust, etc. a When installing the seal, do not apply oil, grease, etc. to the shaft. Wipe oil thor- oughly from the shaft. a Never remove the internal plastic cylin- der of the spare seal before installing the seal. iv) Tighten the bolt of tool A2 evenly until the end of tool A2 touches the end of crankshaft (14) to press fit seal (12).

a When press fitting the seal, take care not to damage the lip on the PTO side with the tool, etc. a After press fitting the seal, remove the red sealant layer on its periphery. a Seal driving dimension a : 16 mm +1 0 i) Put the large inside diameter side b of inter- nal plastic cylinder (13) to the end of crank- shaft (14). a Take care not to mistake the direction of the plastic internal cylinder. 2 Lip: Lithium grease (G2-LI) 30-24 D85EX-15 (2)