Komatsu — REMOVAL AND INSTALLATION

DISASSEMBLY AND ASSEMBLY ENGINE REAR SEAL REMOVAL AND INSTALLATION OF ENGINE REAR SEAL SPECIAL TOOLS 4. Remove rear seal (2). [*2] REMOVAL k Disconnect the cable from the negative (–) ter- minal of the battery. INSTALLATION Carry out installation in the reverse order to removal. 1. Remove the damper assembly. For details, see REMOVAL OF DAMPER ASSEMBLY. 2. Using eyebolt [1], sling the flywheel assembly temporarily and remove the 6 mounting bolts. [*1] [*1] a Apply clean lubricating oil (E030-CD) all over the threads, seats, and washers of the bolts. a Tighten the 6 flywheel mounting bolts in the order of 1 – 6 as shown in the following fig- ure. a Tighten each mounting bolt twice.

3 Mounting bolt: 1st tightening torque: 147 ± 19.6 Nm {15 ± 2.0 kgm} 2nd tightening torque: 289.1 ± 19.6 Nm {29.5 ± 2.0 kgm} 3. Lift off flywheel assembly (1). 4 Flywheel assembly: 58 kg D85EX-15 30-25 (2) Symbol Part No. Part name Necessity Q'ty New/Remodel Sketch A3 1 795-931-1210 Push tool t 1 • 01050-31625 • Bolt t 3 • 01050-31645 • Bolt t 3 2 795-931-1220 Push tool t 1 • 01050-31645 • Bolt t 3