DISASSEMBLY AND ASSEMBLY ENGINE REAR SEAL [*2] Procedure for installing rear seal (2) a Before installing the Teflon seal (lay-down lip seal), check the shaft for wear. Then, install the "standard seal A " or the "seal with sleeve B " according to the check result. If the shaft is still glossy (If the wear depth felt with a finger cushion is 10 µm or less) and it does not have a flaw, install the "stan- dard seal A ". In other cases, install the "seal with sleeve B ". 2) Evenly push in the metallic ring of seal (2) with both hands, getting over the large diam- eter side of the internal plastic cylinder. 3) After pushing in seal (2), remove internal plastic cylinder (3).
a When removing, take care not to dam- age the seal lip. Procedure for installing standard seal A a Before installing the seal, check the rims of the crankshaft end, sliding faces of the lip, and housing for flaw, burr, sharp fin, rust, etc. a When installing the seal, do not apply oil, grease, etc. to the shaft. Wipe oil thoroughly from the shaft. a Never remove the internal plastic cylinder (3) of the spare seal before installing the seal. 4) Tighten the bolt of tool A3-1 evenly until the end of tool A3-1 touches the end of crank- shaft (4) to press fit seal (2). a When press fitting the seal, take care not to damage the lip on the damper side with the tool, etc.
a After press fitting the seal, remove the red sealant layer on its periphery. 1) Put the large inside diameter side b of inter- nal plastic cylinder (3) to the end of crank- shaft (4). a Take care not to mistake the direction of the plastic internal cylinder. 30-26 D85EX-15 (2)