Komatsu — REMOVAL AND INSTALLATION

DISASSEMBLY AND ASSEMBLY ENGINE REAR SEAL Procedure for installing seal with sleeve B a Before installing the seal, check the rims of the crankshaft end, sliding faces of the lip, and housing for flaw, burr, sharp fin, rust, etc. a When installing the seal, do not apply oil, grease, etc. to the shaft. Wipe oil thoroughly from the shaft. a Handle the seal and sleeve as an assembly. Never separate them from each other. 3) Remove tool A3-2 and install tool A3-1 . 4) Tighten the bolt of tool A3-1 evenly until the end of tool A3-1 touches the end of crank- shaft (4) to press fit seal with sleeve (2). a After press fitting the seal, remove the red sealant layer on its periphery.

1) Set seal with sleeve (2) to tool A3-2 . a Take care not to mistake the direction of the seal. 2 Internal cylinder of sleeve: Gasket sealant (LG-7) 2) Put the sleeve of the seal to the end of the crankshaft and tighten the bolt of tool A3-2 evenly until the end of tool A3-2 touches the end of crankshaft (4) to press fit seal with sleeve (2). D85EX-15 30-27 (2)