Komatsu — REMOVAL

DISASSEMBLY AND ASSEMBLY ENGINE CYLINDER HEAD REMOVAL AND INSTALLATION OF ENGINE CYLINDER HEAD ASSEMBLY SPECIAL TOOLS 8. Remove the 4 mounting bolts and bracket (6). REMOVAL k Disconnect the cable from the negative (–) ter- minal of the battery. 1. Remove the engine hood assembly. For details, see REMOVAL OF ENGINE HOOD ASSEMBLY. 2. Close the fuel supply valve of the fuel tank. 9. Close hose valve (8) of corrosion resistor (7), remove hose clamp (9), and remove the corro- sion resistor and bracket (10) together. a Move the corrosion resistor aside. 3. Remove drain cover (1) of the engine under- cover and drain the cooling water. 5 Cooling water: Approx. 80 l 4.

Remove the both engine side covers. 10. Disconnect centralized connectors E21 (11) and E22 (12). 5. Disconnect dust indicator hose (2) from the dust indicator. 11. Disconnect boost pressure sensor connector PIM (13). 6. Loosen the clamp and disconnect hose (3). [*1] 7. Remove band (4) and air cleaner assembly (5). [*2] 12. Remove 2 clamps (15) of wiring harness (14) of centralized connector E21 (11). 13. Disconnect wiring harness (17) on the ribbon heater side of ribbon heater relay (16) and remove ribbon heater relay (16). [*3] 14. Remove turbocharger lubrication tube clamp plate (18). 15. Loosen the hose clamp, disconnect hose (19), and remove air intake connector (20).

[*4] 30-28 D85EX-15 (2) Symbol Part No. Part name Necessity Q'ty New/Remodel Sketch A4 790-331-1110 Wrench t 1