STRUCTURE, FUNCTION AND MAINTENANCE STANDARD TRANMISSION ECMV Outline of ECMV The ECMV (Electronic Control Modulation Valve) consists of the following two units, a pressure control valve and fill switch. Pressure control valve Converts a current sent from the transmission controller to the proportional solenoid valve, to an oil pressure. Fill switch Detects that the clutch is filled with oil. It has the functions below. 1) It outputs a signal (fill signal) to the controller as soon as the clutch is filled with oil to report the completion of filling.
2) It outputs a signal (fill signal) to the controller while an oil pressure is applied to the clutch to report the presence/absence of oil pres- sure. A region: Before gear shift (When draining) B region: Filling starts (During trigger) C region: Filling finishes D region: Voltage regulation E region: During filling ECMV and proportional solenoid One proportional solenoid is attached to one ECMV. After receiving the command current from the controller, it produces thrust in the figure below. By making the proportional solenoid-produced thrust act on the pressure control valve spool, it produces an oil pressure shown in the figure below.
By controlling the amount of command current, the thrust is changed to operate the pressure control valve, controlling the oil flow and oil pressure. ECMV and fill switch One fill switch is attached to one ECMV. When the clutch completes filling, the pressure of the clutch turns "ON" the fill switch. By this sig- nal, the oil pressure starts build-up. 10-32 D85EX-15