DISASSEMBLY AND ASSEMBLY DAMPER 10. Using a eyebolt, sling damper cover assembly (7) temporarily and remove the mounting bolts. [*2] INSTALLATION Carry out installation in the reverse order to removal. 11. Using 2 forcing screws, lift off damper cover assembly (7). [*3] a Lower the damper cover assembly to the floor. [*1] 3 Mounting bolt: 98.1 – 122.6 Nm {10 – 12.5 kgm} 4 Damper cover assembly: 57 kg [*2] 3 Damper cover assembly mounting bolt: 98.1 – 122.6 Nm {10 – 12.5 kgm} [*3] a When installing the damper assembly, degrease the shaft spline and apply dry lubri- cant A and leave it as it is for 2 - 3 minutes.
Then, apply extreme pressure lithium grease containing molybdenum B to the shaft spline. 12. Using a eyebolt, sling damper assembly (8) tem- porarily and remove the mounting bolts. [*4] 13. Using 2 guide bolts, lift off damper assembly (8). a Lift up the damper assembly, and then lower it to the floor. [*4] 3 Damper assembly mounting bolt: 98.10 – 122.6 Nm {10 – 12.5 kgm} 4 Damper assembly: 74 kg Refilling with oil Add oil through the oil filler of the damper assem- bly to the specified level. Run the engine to cir- culate the oil through the system. Then, check the oil level again. 5 Oil in damper chamber: Approx. 1.5 l 3 Drain plug:
58.8 – 78.5 Nm {6 – 8 kgm} 30-48 D85EX-15 (2) A Molybdenum disulfide dry lubricant • Sumiko lubricant: Rocol Dry Splay or equivalent B Extreme pres- sure lithium grease con- taining molyb- denum • Kyodo Yushi: Morilex No. 2 • Showa-Shell: Letinax AM • Nippon oil: Moritex