DISASSEMBLY AND ASSEMBLY TORQFLOW TRANSMISSION 3) Disassemble No. 2 housing and No. 2 carrier assembly according to the following proce- dure. i) Remove snap ring (51) and pull No. 2 carrier assembly (52) out of No. 2 hous- ing (53). 12. No. 3 discs and plates Remove springs (140), discs (68), and plates (69). 13. No. 3 ring gear Remove No. 3 ring gear (70). 14. No. 3 and No. 4 carriers assembly 1) Remove No. 3 and No. 4 carriers (71). ii) Remove spacer (54) from No. 2 carrier assembly (52). iii) Remove No. 2 ring gear (56). iv) Pull out shaft (57) and remove thrust washer (58), gear (59), bearing (60), and ball (61). v) Remove seal ring (133). 2) Disassemble No. 3 and No.
4 carriers assem- bly according to the following procedure. i) Remove seal ring (72). ii) Drive pin (73) into shaft (74). iii) Drive out shaft (74) from No. 3 carrier side. iv) Remove thrust washer (76), No. 4 plane- tary gear (77), and bearing (78). a Pull the pin out of the shaft. vi) Remove snap ring (49) which was removed in step 11-1). vii) Remove snap ring (63) and ring gear (64). D85EX-15 30-65 (2)