DISASSEMBLY AND ASSEMBLY TORQFLOW TRANSMISSION ASSEMBLY 3) Install snap ring (136). Precautions for assembly a Clean the all parts and check them for dirt or damage before installing. a Coat the sliding surfaces of each part with engine oil before installing. a Install the seal ring a of each piston with the pressure receiving side b directed to the housing c as shown in the figure. a Apply grease (G2-LI) to each metallic seal ring and install it evenly. 2. Cage (For fixing No. 5 carrier) 1) Using the push tool, press fit bearing (124) to cage (125). 1. Output shaft 1) Press fit the bearing (137) to shaft (117) and install snap ring (120). 2 Seal ring:
Grease (G2-LI) 3) Install cage (114) to case (116). a Press fit the inner race side of the bear- ing. 4) Install snap ring (113). 2) Install seal rings (138) and (139). 2) Using the push tool, install shaft assembly (117) to case (116). a Push the outer race side of the bearing with a press to install the shaft assembly. 30-68 D85EX-15 (2)