Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY TORQFLOW TRANSMISSION 3. No. 5 sun gear 1) Install snap ring (126). 2) Install No. 5 sun gear (112). 10. No. 5 carrier and No. 4 ring gear assembly 1) Assemble No. 5 carrier assembly according to the following procedure. i) Set No. 4 ring gear (99) to carrier (100) and install snap ring (98). 4. No. 4 sun gear. 1) Install No. 4 sun gear (111). 2) Install collar (110). 3) Install snap ring (109). 5. No. 5 ring gear Install No. 5 ring gear (107). 6. No. 5 piston Install the seal ring and No. 5 piston (108). ii) Install bearing (96) to gear (95) and fit thrust washers (94) to both sides, and then set them to carrier (100). iii) Install ball (97) and shaft (93). 7.

Guide pin Install guide pin (103). 8. No. 5 discs, plates, and springs 1) Install discs (105) and plates (106). a Discs: 3 pieces, Plates: 2 pieces 2) Install springs (104). a Free length of spring: 59 mm 9. No. 4 housing 1) Install the seal ring and No. 4 piston (102). 2) Install No. 4 housing (101). a Check that spring (104) is fitted to the groove. 2) Using guide bolt [9], install No. 5 carrier and No. 4 ring gear assembly (92). 2 Mounting bolt: Adhesive (LT-2) 3 Mounting bolt: 66.1 ± 7.4 Nm {6.75 ± 0.75 kgm} D85EX-15 30-69 (2)