DISASSEMBLY AND ASSEMBLY TORQFLOW TRANSMISSION 11. No. 4 discs, plates, and springs Install No. 4 discs (89), plates (90), and springs (88). a Discs: 3 pieces, Plates: 2 pieces a Free length of spring: 59 mm iv) Install bearing (78) to No. 4 planetary gear (77) and fit thrust washers (76) to both sides, and then set them to the car- rier. v) Install shaft (74), matching its pin hole to the pin hole of the carrier. vi) Check that the pin holes are matched to each other and drive in pin (73). vii) Install seal ring (72). 12. No. 3 housing assembly 1) Install the seal ring and No. 3 piston (87). 2) Install No. 3 housing (86). a Check that springs (88) are fitted in the grooves.
2) Matching the sun gear to the ring gear, install No. 3 and No. 4 carrier assembly (71). a Take care that your fingers will not be caught. 13. No. 3 and No. 4 carrier assembly 1) Assemble No. 3 and No. 4 carrier assembly according to the following procedure. i) Press fit bearing (85) and install snap ring (84). ii) Install bearing (82) to No. 3 planetary gear (81) and fit thrust washers (80) to both sides, and then set them to the car- rier. iii) Install ball (83) and shaft (79). 14. No. 3 ring gear Install No. 3 ring gear (70). a Install the ring gear with the notched side of the external teeth down. 15. Guide pin Install guide pin (44). 16. No. 3 discs and plates 1) Install No.
3 discs (68) and plates (69). a Discs: 3 pieces, Plates: 2 pieces 2) Install springs (140). a Free length of spring: 59 mm 30-70 D85EX-15 (2)