Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY TORQFLOW TRANSMISSION 17. No. 2 housing and No. 2 carrier assembly 1) Assemble No. 2 housing according to the fol- lowing procedure. i) Press fit bearing (68) to No. 2 housing (53) and install snap ring (70). v) Install the seal ring. vi) Install No. 2 ring gear (56). vii) Install spacer (54). a Install the spacer with the cut inside end directed to the carrier. ii) Set ring gear (64) to No. 2 carrier (55) and install snap ring (63). viii) Install No. 2 housing (53) to carrier assembly (52). a Press fit the inner race side of the housing bearing. ix) Install snap ring (51).

iii) Install bearing (60) to gear (59) and fit thrust washers (58) to both sides, then set them to the carrier. iv) Install ball (61) and shaft (57). a After assembling the 2 gear sets, install snap ring (49). 2) Using eyebolts, install No. 2 housing and No. 2 carrier assembly (50). 3) Using tool D1 , push up No. 3 carrier (48) and install snap ring (49). D85EX-15 30-71 (2)