Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY TORQFLOW TRANSMISSION 4) Install sleeve (67). a When installing the sleeve, install it to the bolt hole marked * in the figure with the slit d side down. 5) Install spring (66) and valve (65). 21. No. 1 housing assembly 1) Fit the seal ring and install No. 1 piston (42) to housing (41). 2) Using eyebolts, install No. 1 housing assem- bly (41), matching it to No. 2 piston. a Press the housing and hit the dowel pin. 22. Input shaft and No. 1 carrier assembly 1) Assemble the input shaft and No. 1 carrier assembly according to the following proce- dure. i) Install bearing (26) to gear (25) and fit thrust washers (24) to both sides, and then set them to the carrier.

ii) Install ball (27) and shaft (23). 18. No. 2 discs and plates Install No. 2 discs (46) and plates (47). a Discs: 6 pieces, Plates: 5 pieces 19. No. 2 clutch springs Install springs (45). a Free length of spring: 77 mm 20. No. 2 piston Install the seal ring and No. 2 piston (43), match- ing the spring to the spring groove. iii) Set No. 1 ring gear (22) to No. 1 carrier and install snap ring (21). 30-72 D85EX-15 (2)