DISASSEMBLY AND ASSEMBLY HSS ii) Using the push tool, press fit outer races (105) and (107) to cage (103). iii) Place bevel pinion (102) on the press stand and set cage (103). 4) Using guide bolt [9], install shims (96) and bevel pinion assembly (95). a Install shims of the thickness and quan- tity recorded when removed. Standard shim thickness: 2 mm Varieties of shim thickness: 0.2 mm, 0.3 mm, 1.0 mm iv) Press fit bearing (104) to cage (103) with the press. v) Secure the pinion with the press and tighten locknut (101) with tool E2 . 2 Locknut: Adhesive (LT-2) 3 Locknut:
392 – 441 Nm {40 – 45 kgm} vi) After tightening the nut, return it until 1 of 8 pin holes on it is matched to 1 of 5 pin holes on the pinion shaft. a Return the nut by 0 – 9°. a Tighten the nut, while turning the cage. a After tightening the nut, check that the bevel pinion rotates smoothly. 4. Adjusting backlash and tooth contact 1) Adjusting backlash Apply the probe of dial gauge [13] to the tooth tip at the end of the bevel gear at right angles. Fix the bevel pinion and move the bevel gear forward and backward, and read the value at this time. a Standard backlash: 0.2 – 0.28 mm a Measure the backlash diagonally at 3 or more places.
If the measured backlash is out of the standard range, adjust it according to the following procedure. vii) Install pin (100) and plate (99), and then tighten bolt (97). 3 Bolt: 11.8 – 14.7 Nm {1.2 – 1.5 kgm} D85EX-15 30-85 (2)