Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY HSS a Adjust the backlash by increasing or decreasing the thickness of both shims. Do not change the total thickness of both shims, however, so that the pre-load will not change. (If the thickness of the shim on one side is increased, decrease the thickness of the other side, and vice versa.) When backlash is too small Decrease the thickness of the shim on the right side of the chassis and increase the thickness on the left side by the same quantity.

(Move the bevel gear in direc- tion A .) 2) Adjusting tooth contact Testing i) Apply red lead thinly to the tooth surfaces of the bevel gear and turn the bevel gear in the forward and reverse directions, then check the tooth contact pattern on the bevel gear. ii) The tooth contact must be as follows (The standard distance is measured from the tooth tip of the bevel pinion.) a) Center of tooth contact: 20 – 40% of face width (from small end) b) Width of tooth contact: 30 – 50% of face width c) Center of tooth contact: 35 – 65% of tooth depth d) Width of tooth contact:

60 – 80% of tooth depth Check that there is not a strong contact at the tips A or roots B of the teeth of both small end C and large en d D . a If the bevel gear and bevel pinion are adjusted in this way, their teeth come in contact with each other correctly when they are loaded. When backlash is too large Decrease the thickness of the shim on the left side of the machine body and increase the thickness on the right side by the same quantity. (Move the bevel gear in direction B .) 30-86 D85EX-15 (2)