DISASSEMBLY AND ASSEMBLY HSS Adjusting If the tooth contact pattern is not proper, adjust the tooth contact according to the fol- lowing procedure. i) If the bevel pinion is too far from the cen- ter line of the bevel gear, the contact is at the small end of the bevel gear tooth faces curved outward and at the large end of the bevel gear tooth faces curved inward. In this case, adjust the tooth contact according to the following procedure. Adjust the thickness of the shims on the bevel pinion side to move the bevel pin- ion in direction A . Move the bevel gear in direction B , then check the tooth contact pattern and back- lash again. 5. Sun gear 1) Install snap ring (93) to the shaft.
a Perform this work for only right side of the machine. 2) Install collar (71). 3) Install bearing (74) with the push tool. ii) If the bevel pinion is too close to the cen- ter line of the bevel gear, contact is at the large end of the bevel gear tooth faces curved outward and the small end of the bevel gear tooth faces curved inward. In this case, adjust the tooth contact according to the following procedure. Adjust the thickness of the shims on the bevel pinion side to move the bevel pin- ion in direction A . Move the bevel gear in direction B , then check the tooth contact pattern and back- lash again. a Do not change the total thickness of the shims on both sides.
iii) When adjustment is finished, tighten the mounting bolts of the cage and bevel pin- ion assembly to the specified torque. 4) Install sun gear (72). 5) Install bearing (98) with the push tool. a Press fit the inner race and outer race simultaneously. 3 Mounting bolts of cage and bevel pinion assembly: 98 – 123 Nm {10 – 12.5 kgm} D85EX-15 30-87 (2)