DISASSEMBLY AND ASSEMBLY HSS ii) Install outer race (29) to cover (32). iii) Press fit bearing (28) to cover (32), then install snap ring (23). 3) Intermediate gear assembly i) Install bearing (17) and spacer (17a) to gear (15). iv) Using puller [18], press fit shaft (21) to the inner race side of bearing (28). a Replace the bolt with one having dif- ferent length. ii) Press fit shaft (14) to the inner race side of bearing (17). Fit ball (16) halfway and press fit completely. a Before the shaft enters the cover, position the ball accurately. v) Install gear (22). vi) Install holder (20) and tighten bolt (19). 3 Mounting bolt:
98 – 123 Nm {10 – 12.5 kgm} iii) Install holder (13) and tighten bolt (12). 3 Mounting bolt: 98 – 123 Nm {10 – 12.5 kgm} D85EX-15 30-91 (2)