DISASSEMBLY AND ASSEMBLY HSS 14) Using eyebolts [15] and matching to the guide bolt, set cover (41). a Check that the spring is fitted to both of the piston and case. 15) Compressing the spring with forcing screws [17] and nuts [16], press fit the inner race side of the bearing to the hub assembly. 19) Brake and carrier assembly i) Equalize the projection of the seal rings from the shaft on the carrier side. ii) Using tool E1 , install brake and carrier assembly (34). 7. Cover assembly Assembly of cover assembly 1) Install valve (31) and spring (30) to the cover, then install the plug. 16) Install spacer (38) and snap ring (37). 17) Install flange (36).
18) Remove the bolts and nuts used to compress the spring, then install 4 bolts (40). 2) Left carrier drive gear i) Press fit bearing (26) to shaft (21). 30-90 D85EX-15 (2)