DISASSEMBLY AND ASSEMBLY TORQUE CONVERTER 5. Pump assembly 1) Remove pump assembly (16) from stator shaft (17). ASSEMBLY a Clean the all parts and check them for dirt or damage before installing. a Drop engine oil onto the rotating parts of each bearing and rotate it several turns. a Check that the snap rings are fitted in the grooves. a Apply grease (G2-LI) thinly to each seal ring. 1. Pump assembly 1) Press fit bearing (21) to cage (20) and install snap ring (22). 2) Remove mounting bolts (19), and then pull case assembly (18) out of pump assembly (23). 2) Install cage assembly (18) to pump (23) and tighten mounting bolts (19). 3 Mounting bolt:
58.9 – 73.6 Nm {6 – 7.5 kgm} D85EX-15 30-101 (2)