DISASSEMBLY AND ASSEMBLY TORQUE CONVERTER 3) Install seal ring (24) to stator shaft (17). a Apply grease (G2-LI) to the seal ring and put the openings opposite to each other. Install pump assembly (16) to stator shaft (17). a Press the inner race side of the bearing to press fit. a After press fitting the bearing, drop engine oil a little onto it and rotate pump assembly (16) at least 10 turns. 3. Case 1) Install bearing (25) and case (26). 2) Press the inner race side of the bearing to install case assembly (10) to the boss of tur- bine (11). 2. Stator 1) Install race (13). 2) Install snap ring (14). 3) Install spacer (9). 4) Install snap ring (8).
3) Install stator (15) and tighten bolts (12). 2 Mounting bolt: Adhesive (LT-2) 3 Mounting bolt: 58.9 – 73.6 Nm {6 – 7.5 kgm} 30-102 D85EX-15 (2)