DISASSEMBLY AND ASSEMBLY FAN PUMP REMOVAL AND INSTALLATION OF FAN PUMP ASSEMBLY REMOVAL k Disconnect the cable from the negative (–) ter- minal of the battery. 8. Disconnect EPC valve connector FAC (4). 9. Disconnect pump hoses. (5): Discharge hose (6): EPC valve basic pressure input hose (7): Drain hose 1. Drain the oil. 6 Hydraulic tank: D85EX-15; Approx. 150 l D85PX-15; Approx. 140 l 2. Remove the engine hood assembly. For details, see REMOVAL OF ENGINE HOOD ASSEMBLY. 3. Remove the operator's cab assembly. For details, see REMOVAL OF OPERATOR'S CAB ASSEMBLY. 4. Remove the floor frame assembly. For details, see REMOVAL OF FLOOR FRAME ASSEMBLY. 5. Open undercover (1). 10.
Sling the pump assembly temporarily and remove mounting bolts (8). 11. Lift off pump assembly (9). 4 Pump assembly: 28 kg 6. Remove tube clamp U-bolt (2). 7. Remove 4 suction tube mounting bolts (3). INSTALLATION Carry out installation in the reverse order to removal. Refilling with oil Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then, check the oil level again. 5 Hydraulic tank: D85EX-15; Approx. 150 l D85PX-15; Approx. 140 l Bleeding air Bleed air from the fan pump. For details, see TESTING AND ADJUSTING, Bleeding air from fan pump. D85EX-15 30-107 (2)