Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY FINAL DRIVE ASSEMBLY 3) Using push tool [4], press fit bearings (47) and (48) to gear (49). Press fitting force for bearing: 6 – 17 kN {0.6 – 1.7 tons} 4) Install gear assembly (45). a Lower and install the gear assembly slowly so that the oil seal lip will not be damaged. a Clean the all parts and check them for dirt or damage before installing. a Coat sliding surfaces of each part with engine oil before installing. 1. Gear assembly 1) Using tool J5 , install oil seal (44) to case (34). a When installing the oil seal, take care of its direction. a Apply gasket sealant thinly to the inside of the housing hole and wipe off the pro- jected part. 2 Oil seal lip:

Grease (G2-LI) 2 Oil seal fitting surface: Gasket sealant (LG-5) 2. Cage assembly 1) Using tool J5 , install oil seal (42) to cage (40). a When installing the oil seal, take care of its direction. a Apply gasket sealant thinly to the inside of the housing hole and wipe off the pro- jected part. 2 Oil seal lip: Grease (G2-LI) 2 Oil seal fitting surface: Gasket sealant (LG-5) 2) Using tool J5 , press fit bearing outer race (43) to case (34). Press fitting force for outer race: 1 – 14 kN {0.1 – 1.4 tons} D85EX-15 30-117 (2)