DISASSEMBLY AND ASSEMBLY FINAL DRIVE 5) Tighten mounting bolts (11). 3 Mounting bolt: 455 – 565 Nm {46.5 – 58 kgm} 2) Install sprocket (9) to the sprocket hub. 3 Mounting bolt: 931 – 1,127 Nm {95 – 115 kgm} 6) Using tool J4 , press fit floating seal (10). a Degrease the O-ring and O-ring fitting surfaces thoroughly and dry them before installing. a After installing the floating seal, check that its slant is less than 1 mm. 3) Using tool J4 , press fit floating seal (7). a Degrease the O-ring and O-ring fitting surfaces thoroughly and dry them before installing. a After installing the floating seal, check that its slant is less than 1 mm. 6.
Sprocket hub assembly 1) Using tool J5 , press fit bearing outer race (8). Press fitting force for bearing: 15 – 35 kN {1.5 – 3.6 tons} 4) Using eyebolts, install sprocket hub assem- bly (5) to the cover assembly. a Check that the sliding surfaces of the floating seal are free from dirt and apply engine oil to them thinly. 5) Set bearing (6). 30-122 D85EX-15 (2)