Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY FINAL DRIVE 3) Set the planetary gear assembly to the car- rier and press fit shaft (23). a Aligning the holes of the bearing and spacer with each other, press fit the shaft gradually. 5. Cover assembly 1) Install ring gear (19) and ring (18) and secure them with 6 lock plates (17). 2) Install spacer (16). 3) Using tool J3 , press fit bearing (15). Press fitting force for bearing: 24 – 52 kN {2.4 – 5.3 tons} 4) Install bolt (21) and holder (22). 2 Mounting bolt: Adhesive (LT-2) 3 Mounting bolt: 230 – 289 Nm {23.5 – 29.5 kgm} 4) Using eyebolts, install the O-ring to cover assembly (12), and then install them to the case assembly.

a Check that the mating faces of the case and cover are free from bruise, rust, oil, grease, dirt, and water. 5) Using 3 eyebolts, install carrier assembly (20). 2 Mounting bolt: Gasket sealant (LG-7) D85EX-15 30-121 (2)