DISASSEMBLY AND ASSEMBLY IDLER 5. Using tool L1 , install floating seal (12) to idler (7). a Degrease the O-ring and O-ring fitting sur- faces thoroughly and dry them before install- ing. a After installing the floating seal, check that its slant is less than 1 mm. 8. Refill the idler with oil. a The idler may be refilled with oil at this time. For the ordinary method of refilling with oil, see REFILLING WITH OIL. 5 Idler: Approx. 0.33 – 0.37 l 6. Sling idler (7) and install it to shaft support assembly (10). 3 Oil fill plug: 157 – 255 Nm {16 – 26 kgm} 9. Using tool L1 , install floating seal (9) to support (8).
a Degrease the O-ring and O-ring fitting sur- faces thoroughly and dry them before install- ing. a After installing the floating seal, check that its slant is less than 1 mm. 7. Using tool L1 , install floating seal (11) to idler (7). a Degrease the O-ring and O-ring fitting sur- faces thoroughly and dry them before install- ing. a After installing the floating seal, check that its slant is less than 1 mm. D85EX-15 30-131 (2)