Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY IDLER 11. Remove nut (14) and drive out bolt (15) from the nut side. 2. Install the O-ring to shaft (17), and then install them to support (16). a When installing shaft (17), match its groove to the groove of the support. a Install the shaft with the opposite end of the oil filler ahead. 12. Similarly to step 6, using push puller [1], pull shaft (17) out of support (16). 3. Drive bolt (15) and tighten nut (14). 3 Mounting nut: 157 – 255 Nm {16 – 26 kgm} 13. Remove 2 bushings (18) from idler (7). 4. Using tool L1 , install floating seal (13) to shaft and support assembly (10), and then install the O-ring to shaft (17).

a Degrease the O-ring and O-ring fitting sur- faces thoroughly and dry them before install- ing. a After installing the floating seal, check that its slant is less than 1 mm. ASSEMBLY 1. Using push tool [4], press fit 2 bushings (18) to idler (7). Press fitting force for bushing: 4.9 – 148.7 kN {1.5 – 15.2 tons} 30-130 D85EX-15 (2)