Komatsu — DISASSEMBLY

DISASSEMBLY AND ASSEMBLY RECOIL SPRING DISASSEMBLY AND ASSEMBLY OF RECOIL SPRING ASSEMBLY SPECIAL TOOLS If cylinder (18) is not broken and shaft end nut (21) is not lost, disassemble the yoke and piston assembly according to the following procedure. DISASSEMBLY 1. Remove yoke and piston assembly (2) from recoil spring assembly (1). 3. Remove holder (14) from recoil spring case (13). k Never stand in front or in the rear of the recoil spring assembly to prevent danger. 2. Disassembly of yoke and piston assembly 1) Remove snap ring (3), ring (4), packing (5), and ring (6). 2) Remove bolt (7), plate (8), and washer (9). 3) Using push tool (12) and a press, pull piston (11) out of yoke (10). 4.

Disassembly of holder 1) Remove cover (15) from holder (14). 2) Remove seal (16) and bushing (17) from holder (14). D85EX-15 30-135 (2) Symbol Part No. Necessity Part name Q'ty New/Remodel Sketch M1 791-685-8006 Compressor t 1 791-635-3160 Extension t 1 791T-630-2610 Spacer t 1 N Q 790-101-1300 Cylinder t 1 790-101-1102 Hydraulic pump t 1