Komatsu — DISASSEMBLY

DISASSEMBLY AND ASSEMBLY RECOIL SPRING 5. Remove lock plate (19) form cylinder (18), and then remove lubricator (20). 9. Take recoil spring (23) and cylinder (18) out of recoil spring case (13). 10. Remove bushing (24) from cylinder (18). 11. Remove seal (25) and bushing (24) from recoil spring case (13). 6. Set recoil spring assembly (1) to tool M1 . k Set the spring securely since its installed load is large. a Installed load of spring: 23.2 kN {23,200 kg} When cylinder (18) is broken of shaft end nut (21) is lost, if mounting bolt (26) of holder (14) is removed, recoil spring (23) flies forward. Accordingly, disassemble according to the fol- lowing procedure in this case.

k Never stand in front or in the rear of the recoil spring assembly to prevent danger until holder (14) and recoil spring case (13) are separated and the recoil spring is taken out and safety is confirmed. 7. Apply hydraulic pressure to tool M1 slowly to compress the spring, tighten nut (21) until spacer (22) can be removed, and remove the spacer. 8. Remove nut (21) and reduce the hydraulic pres- sure slowly to release the spring. 1) Set recoil spring assembly (1) to tool M1 . k Set the spring securely since its installed load is large. a Installed load of spring: 23.2 kN {23,200 kg} 2) Apply hydraulic pressure slowly to secure recoil spring assembly (1). 30-136 D85EX-15 (2)