Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY RECOIL SPRING a When compressing the spring, align it with the other parts by using lever block [1], etc. so that the threads will not be damaged. a Installed length of spring: 651 mm 3) Remove mounting bolt (26) of holder (14) under the condition in step 2). 4) Reduce the hydraulic pressure slowly to release the spring. 4. Install nut (21) and spacer (22). ASSEMBLY 1. Using the push tool, press fit bushing (24) to recoil spring case (13) and install seal (25). Press fitting force for bushing: 19.6 – 29.4 kN {2.0 – 3.0 tons} 2 Bushing: Grease (G2-LI) 2. Using the push tool, press fit bushing (24) to cyl- inder (18). Press fitting force for bushing:

19.6 – 29.4 kN {2.0 – 3.0 tons} 2 Bushing: Grease (G2-LI) 5. Reduce the hydraulic pressure slowly to elimi- nate the spring tension, and then remove recoil spring assembly (1) from tool M1 . 3. Install recoil spring (23) and cylinder (18) to recoil spring case (13) temporarily and set tool M1 . k Set the spring securely since its installed load is large. a Installed load of spring: 227.5 kN {23.2 tons} D85EX-15 30-137 (2)