Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY TRACK ROLLER ASSEMBLY a Clean the all parts and check them for dirt or damage before installing. 1. Set track roller (10) on a block. 2. Install the O-ring to bushing (7) and press fit them to track roller (10). a When installing the bushing, match it to the bolt hole of the track roller. 2 Periphery of bushing: Gear oil (G0140) 6. Using tool N1 , install floating seal (5) to bushing (7) and collar (3). a Clean and degrease the O-ring and O-ring fitting surfaces thoroughly and dry them before installing. a After installing the floating seal, check that its slant is less than 1 mm. 3. Turn over track roller (10) and set it on the block and insert shaft (9). 4.

Install the O-ring to bushing (7) and using the push tool [3], press fit them to track roller (10). a When installing the bushing, match it to the bolt hole of the track roller. 2 Periphery of bushing: Gear oil (G0140) 7. Install the O-ring to shaft (9). a Take care not to damage the O-ring. 2 Up to collar mounting portion of shaft: Molybdenum disulfide (LM-P) 8. Set track roller assembly (1) on the block [1]. Using push puller [2], push in collar (3) and install ring (4). 5. Install mounting bolt (8) of bushing (7). 3 Initial torque: 49 ± 10 Nm {5 ± 1 kgm} 2 Mounting bolt: Molybdenum disulfide (LM-P) a After tightening, retighten by 90° ± 5° D85EX-15 30-141 (2)