STRUCTURE, FUNCTION AND MAINTENANCE STANDARD HYDRAULIC, HSS PUMP Outline The engine rotation and torque transmitted to the pump shaft is converted to hydraulic energy and pressurized oil is discharged according to the load. It is possible to change the discharge amount by changing the swash plate angle. The oil inside each cylinder chamber of clinder block (9) is sucked in and dischaged through valve plate (10). Impeller (12) is fixed to shaft (1), and rotates together with the shaft, it makes it easier for the oil sucked in from the suction port to be sucked in and sends it into the cylinder chamber by cen- trifugal force.
Structure Cylinder block (9) is supported to shaft (1) by a spline (13), and shaft (1) is supported by the front and rear bearings. The end of piston (8) has a concave ball shape and shoe (5) is calked to it to form one unit. Piston (8) and shoe (5) from a spherical bearing. Rocker cam (4) holds plane A , and shoe (5) is always pressed against this surface as it slides in a circle. Rocker cam (4) forms a static beaing sending high pressure oil at cylindrical surface B of cra- dle (3), which is fixed to the case, and carries out a sliding movement. Piston (8) carries out motion relative to the axial direction inside each cylinder chamber of cylin- der block (9).
The cylinder block (9) carries out rotation relative to valve plate (10) while sealing the pressurized oil, and this surface ensures that the hydraulic balance is maintained correctly. D85EX-15 10-45