DISASSEMBLY AND ASSEMBLY TRACK SHOE a Final pressing force for pin and bushing: 588 kN {60 tons} Final pressing force C 1.8 x Average press fitting force (Adjust the relief pressure of the link press to set the final pressing force.) 3. Installation of shoe 1) Set the link assembly on the bed and install the shoe with a shoe bolt impact wrench and a torque wrench. a When reusing (reversing) the bushing, set the worn outside surface of the bush- ing on the shoe fitting side of the link (set the bushing with the worn outside sur- face up on the link press). 2 Shoe bolt: Lubricant containing molybdenum disulfide (LM-P) 3 Shoe bolt (Regular link): Single shoe: Initial torque:
343 ± 39 Nm {35 ± 4 kgm} Retightening angle: 120° ± 10° Swamp shoe: Initial torque: 784 ± 79 Nm {80 ± 8 kgm} Retightening angle: 120° ± 10° 8) Using a shoe bolt hole pitch gauge, measure the distance between the shoe bolt holes. When the distance is in the standard range, stop press fitting. other by the mating faces. 4) Place and fit shoes (3) to the mating surface of the links. 5) Check that master bolt (4) can be tightened easily with the fingers, then connect the links with the master bolt. 9) Assemble the master link on the pin side at last. a Check that the master links on both sides are press fitted in parallel. 2 Master bolt:
Lubricant containing molybdenum disulfide (LM-P) 3 Master bolt (Master link) Single shoe: Initial torque: 343 ± 39 Nm {35 ± 4 kgm} Retightening angle: 180° Swamp shoe: Initial torque: 490 ± 49 Nm {50 ± 5 kgm} Retightening angle: 180° 0 - 20 0 - 20 D85EX-15 30-161 (2)