DISASSEMBLY AND ASSEMBLY TRACK SHOE DIMENSIONS TABLE OF FITTING JIG OF LINK PRESS Adjusting Adjust the dimensions of the press fitting jig of the link press to keep the projection of the pin and bush- ing constant and keep the installed dimensions of the seal within the standard range. a If the pin end (part P ) or the sides of the link (parts Q and R ) are worn, add the dimensions of the worn parts when adjusting the standard dimensions so that the projections of the pins and bushings on both sides will be even. Precaution 1. The link receiving faces of jaw (5) must be verti- cal. 2. Replaceable wear plate (6) shown below is desirable. Unit:
mm Dimensions of jig a b c 4 2.0 47.9 D85EX-15 30-163 (2)