Komatsu — DISASSEMBLY

DISASSEMBLY AND ASSEMBLY HYDRAULIC CYLINDER 2. Piston rod assembly Blade lift and ripper lift cylinders 1) Set the cylinder assembly to tool U1 . 2) Using a hydraulic pump or a power wrench, disconnect head assembly (7) from the cylin- der with tool U2 . 3) Pull piston rod assembly (8) out of cylinder (9). a Put an oil pan, etc. under the cylinder to receive oil. 3. Piston assembly Blade lift cylinder 1) Set piston rod assembly (11) to tool U1 . 2) Using tool U3 , remove nut (12) from the cyl- inder. 3) Remove collar (13) and sleeve (14), and then remove piston assembly (15) from pis- ton rod (16). 4) Remove retainer (17) and sleeve (18).

Blade tilt cylinder 1) Remove the mounting bolts and disconnect head assembly (10). 2) Pull piston rod assembly (11) out of cylinder (12). a Put an oil pan, etc. under the cylinder to receive oil. 5) Disassemble the piston assembly according to the following procedure. i) Remove 2 wear rings (19). ii) Remove piston ring (20) from the piston. a Do not remove 6 seats (21) and 3 piston valves (22). D85EX-15 30-179 (2)