DISASSEMBLY AND ASSEMBLY OPERATOR'S CAB 15. Remove 4 respective mounting bolts (20) at both doors of the operator's cab. Arrangement of seals 16. Lift off operator's cab assembly (21). a When lifting off the operator's cab assembly, check that all the wire are disconnected. 4 Operator's cab assembly: 410 kg Installation of seals to air conditioner box 1) Remove dirt, oil, and grease from the top of the floor frame to apply gasket sealant (32). 2) Apply the gasket sealant to the top of the floor frame. For the parts to apply the gasket sealant, see view Z above. (Hunting of position A ) (32): Three bond 1207B INSTALLATION 3) Fit seal (30) to the guide plate of the air con- ditioner box.
Carry out installation in the reverse order to removal. a Pull down seal (30) to press the gasket sealant applied in 2). a Fill the clearance between seal (30) and floor frame with adhesive (LT-1A). Inside of seal: Adhesive (LT-1A) [*1] [*3] a When connecting the connectors, take care not to mistake their Nos. [*2] a After connecting the windshield washer hose and connector, securely install the grommet to the through hole of the cab. 30-192 D85EX-15 (5)