DISASSEMBLY AND ASSEMBLY OPERATOR'S CAB 4) Apply grease (G2-LI) to the outside of seal (30) (sealing face against the cab). a Apply grease so that the cab will slip well and the seal will not be moved or deformed when the cab is installed. 8) Cut seal (22) flush with seal (23). (See figure P.) Fit part k (the joint) to eliminate clear- ance. 9) Seal (31) to the groove first, and then stick seal (23). (See section A – A.) Installation of seals of operator's cab mating faces 1) Sling the operator's cab assembly. 2) Remove dirt, oil, and grease from the seal fit- ting surfaces. k Do not stand under the operator's cab. 3) Referring to the figure, stick seals (22), (23), (24), (25), and (31).
4) Stick the seals in the order of (22), (31), (23), (24), and (25). 5) Fit end part h of seal (22) to the air conditioner box to eliminate clearance. 6) Fit part j (the joint) to eliminate clearance. 7) Use the excessive part of seal (22) as seal (24). a Cab seen from bottom D85EX-15 30-193 (5)